al munload_ramp_offset mro Trendsetter_400/800_Auto Trendsetter_NEWS The munload_ramp_offset parameter is used to calculate how far up the load ramp to move the plate during the first part of the MUNLOAD command. The bottom of the load ramp is first moved in towards the drum. The drum unwinds the plate until the trailing edge has moved the distance specified by munload_ramp_offset up the load ramp, then the load ramp is moved away from the drum and the plate is unwound until the Leading Edge (LE) clamps reach their actuator position. The whole point of this exercise is to avoid crashing the top edge of the plate into the suction-cup side of the picker during a manual plate unload. int32
  • 100
    •
  • 0 to 500 [mm]
    •      cfg
  • ../commands/munload.xmlCommand: munload
  • ../nvs/media_cal_mu.xmlNVS: media mu
    •
  • ..\..\ShowAllErrors.htmFirmware 0 Error Index
  • ..\..\ShowAllCommands.htmFirmware 0 Command Index
  • ..\..\ShowAllNVS.htmFirmware 0 NVS Index
    •  Updated: Wed Jul 16 19:35:52 2008 PST